81. Camshaft Cover Assemble

Camshaft Cover Assemble

Special Tools
* DT 5590 - Bearing and Seal Driver
* J-25254-A - Oil Seal Installer

For equivalent regional tools, refer to Special Tools Special Tools.

Left Camshaft Cover




1. Install the NEW left spark plug shield tube seals using the DT 5590 - driver (1) and J-25254-A - installer (2).




2. Install the NEW left camshaft cover gasket.




3. Install the oil fill cap.





Caution: Refer to Fastener Caution Fastener Caution.

4. Install the fuel injector sight shield cover ballstud and tighten to 10 Nm (89 lb in).





Note: The camshaft cover bolt grommet must be installed into the camshaft cover bolt hole before installing the camshaft cover bolt.

5. Install the NEW left camshaft cover bolt grommets.

Right Camshaft Cover




1. Install the NEW right spark plug shield tube coil seals using the DT 5590 - driver (1) and J-25254-A - installer (2).




2. Install the NEW right camshaft cover gasket.





Note: The camshaft cover bolt grommet must be installed into the camshaft cover bolt hole before installing the camshaft cover bolt.

3. Install the NEW right camshaft cover bolt grommets.