Rear Door Window Glass: Service and Repair

Rear Side Door Window Replacement

Removal Procedure

Warning: Refer to Glass and Sheet Metal Handling Warning Glass and Sheet Metal Handling Warning

1. Lower the window all the way down.
2. Remove the rear side door trim panel. Refer to Rear Side Door Trim Replacement Rear Side Door Trim Replacement
3. Remove the rear side door garnish molding. Refer to Rear Side Door Window Garnish Molding Replacement Rear Side Door Window Garnish Molding Replacement
4. Remove the rear side door water deflector.
5. Remove the rear side door window inner sealing strip. Refer to Rear Side Door Window Inner Sealing Strip Replacement Rear Side Door Window Inner Sealing Strip Replacement
6. Remove the rear side door window belt reveal molding. Refer to Rear Side Door Window Belt Reveal Molding Replacement Service and Repair
7. Connect the rear side door trim panel electrical connector.
8. Run the window to the fully up position.
9. Tape the window in the up position.
10. Loosen rear side door front window run channel bolt.
11. Loosen the window regulator guide nuts 4 revolutions.
12. Using the power window switch, lower the window regulator to the fully down position.
13. Remove the tape.
14. Slide the window down past the window regulator guides and out of the front window run channel.




15. Lift the rear side door window out of the door.

Installation Procedure




1. Install the window down into the door, past the window regulator guides.
2. Raise the window past the window regulator guides.
3. Lower the window into the window regulator guides.
4. Push the glass forward into the front glass run channel.

Note: Start the vehicle in order to ensure maximum power to the window motor. This is required to fully seat the window for adjustment.

5. Start the vehicle.

Caution: Refer to Fastener Caution Fastener Caution

6. Using the power window switch, raise the window to the fully up position. Tighten the window regulator guide nuts to 11 Nm (98 lb in).
7. Install the window into the rear side door front window run channel, tighten the bolts to 9 Nm (80 lb in).
8. Inspect the window for proper operation and a tight seal.
9. Shut off the vehicle.
10. Install the rear side door window belt reveal molding. Refer to Rear Side Door Window Belt Reveal Molding Replacement Service and Repair
11. Install the rear side door window inner sealing strip. Refer to Rear Side Door Window Inner Sealing Strip Replacement Rear Side Door Window Inner Sealing Strip Replacement
12. Install rear side door water deflector.
13. Install the rear side door garnish molding. Refer to Rear Side Door Window Garnish Molding Replacement Rear Side Door Window Garnish Molding Replacement
14. Install the rear side door trim panel. Refer to Rear Side Door Trim Replacement Rear Side Door Trim Replacement