Backlight Extension or Rear Valance

FIGURE 2 - Bonnet Assembly:

Removal:

1. Cover rear of vehicle to protect paint.

2. Open rear compartment lid.

3. Remove screws securing backlight extension or valance to body and remove extension or valance (13, Figure 2).

Installation:

1. Install body caulking compound over attaching screw holes to prevent water entry into body.

2. Position backlight lower extension to body and install attaching screws.

3. Close rear compartment lid.

4. Remove all previously installed protective covers and tape from vehicle.
For warranty purposes, use the following Labor Operations:
"E" "K"

B2072 Windshield Header Lace - R & R or Replace .2 .2

B2076 Lower Rear Valance - Cover ("E") or .3
Extension ("K")

B3510 Feature Strip Bow - R & R or Replace .3 .3
ADD: To Replace Retainer .2 .2

B2079 Cover and Cap Complete (Bonnet) - Replace 2.3 2.3