A/T - New Design Selective Washer for Internal Repairs
Bulletin No. T 83-113File In Group 7
Number 83
Date July '83
NEW DESIGN SELECTIVE WASHER 1981-1983 THM 200-C, 200-4R, AND 325-4L
Any time internal repairs are performed to the above listed transmissions, inspect the selective washer used to establish front (or input) unit end play for wear or damage.
Beginning in late March, 1983, a new design selective washer went into production and is now available for service that is used on the following parts:
^ Turbine shaft to output shaft - THM 200-C
^ Forward clutch shaft to output shaft - THM 200-4R
^ Input shaft to output shaft - THM 325-4L
FIGURE 1 - NEW DESIGN SELECTIVE WASHER:
These new service parts are made from a different material and can be identified by a raised portion on the identification tab as shown in Figure 1.
When servicing any THM 200-C, 200-4R, or 325-4L transmission that necessitates the replacement of the front (or input) unit selective washer due to wear or damage, use the following service procedure:
SERVICE PROCEDURE
1. Inspect the appropriate two shafts for wear or damage on the selective washer mating surfaces. If wear or damage is found, replace the necessary shaft(s) to prevent future wear.
2. Select the proper selective washer from the chart below:
SELECTIVE WASHER CHART (Front End Play)
Identification
Thickness (mm) Thickness (in.) Number Color Part Number
1.66 - 1.77 0.065 - 0.070 1 - 8639291
1.79 - 1.90 0.070 - 0.075 2 - 8639292
1.92 - 2.03 0.076 - 0.080 3 Black 8639293
2.05 - 2.16 0.081 - 0.085 4 Lt. Green 8639294
2.18 - 2.29 0.086 - 0.090 5 Scarlet 8639295
2.31 - 2.42 0.091 - 0.095 6 Purple 8639296
2.44 - 2.55 0.096 - 0.100 7 Cocoa Brown 8639297
2.57 - 2.68 0.101 - 0.106 8 Orange 8639298
2.70 - 2.81 0.106 - 0.111 9 Yellow 8639299
2.83 - 2.94 0.111 - 0.116 10 Lt. Blue 8639300
2.96 - 3.07 0.117 - 0.121 11 Blue 8639301
3.09 - 3.20 0.122 - 0.126 12 - 8639302
3.22 - 3.33 0.127 - 0.131 13 Pink 8639303
3.35 - 3.46 0.132 - 0.136 14 Green 8639304
3.48 - 3.59 0.137 - 0.141 15 Gray 8639305
3. Check the front end play to verify the proper washer selection, following procedures outlined in your Service Manual. Front end play for THM 200-C, 200-4R or 325-4L transmissions should be 0.56 mm - 1.30 mm (0.022 - 0.051 in.).