Cylinder Head Replacement - Right Side

REMOVE OR DISCONNECT
1. Disconnect the battery negative cable.
2. Remove intake manifold.
3. Remove right exhaust manifold.
4. Remove spark plug wires.
5. Remove push rods.
6. Remove the right cylinder head.

INSTALL OR CONNECT

Note The gasket surfaces on both the head and cylinder case deck must be clean of any foreign matter and free of nicks or heavy scratches. Cylinder bolt threads in the case and threads on the cylinder head bolts must be clean. Dirt will affect bolt torque.

1. Place the gasket in position, over the dowel pins, with the note. "This Side Up" showing.
2. Install cylinder head.
3. Coat the cylinder head bolt threads with sealer, p/n 1052080 or equivalent and install bolts. Torque bolts in proper sequence to 95 N m (70 ft. lbs.)
4. Install push rods and loosely retain with rocker arms. Make sure lower ends of push rods are in lifter seats.
5. Install intake manifold.
6. Install right exhaust manifold.