Right Side
REMOVE OR DISCONNECT
1. Disconnect the battery negative cable.
2. Remove Power Steering pump and bracket, EGR valve, and EGR valve transfer tube.
3. Remove intake runners.
4. Remove rocker arm cover attaching nuts.
5. Remove rocker arm cover. If cover adheres to the cylinder head, shear off by bumping end of Valve cover with palm of hand or rubber mallet. If cover still will not come loose, CAREFULLY pry until loose. DO NOT DISTORT SEALING FLANGE.
INSTALL OR CONNECT
1. Clean sealing surface on cylinder head, Valve cover and intake manifold. Clean all old sealer and make sure no oil or water is present when applying new sealant.
2. Place a 3 mm diameter (1/8 in.) dot of RTV sealant, #ft 1052917 or equivalent, at the intake manifold and cylinder head split line.
3. Install cover gasket, cover, load spreaders and torque nuts to 10 Nm (90 in. lbs.)
4. Install Power Steering pump and bracket, EGR valve, and EGR valve transfer tube.
5. Install PFI parts that were removed.
6. Reconnect the battery negative cable.