Back Window Reveal Molding - Service Procedure

Bulletin No. T 87-11
File in Group 10
Number 82
Corp. Ref. No. 611501
Date Sept. '86
SUBJECT: BACK WINDOW REVEAL MOLDING

MODELS AFFECTED: 1986 SEDAN DE VILLE

This bulletin contains the back window garnish molding removal and installation procedure on 1986 Sedan de Villes which was inadvertently omitted from the 1986 Body Service Manual.

Removal: Remove the following components as listed in the 1986 Body Service Manual.

1. Remove rear seat cushion.

2. Remove rear seat back cushion.

3. Remove quarter upper trim panels.

4. Remove back window garnish molding.

5. Remove center high level stop lamp and bracket.

6. Remove rear seat to back window trim.

7. Remove rear compartment front panel.

Figure 1 - Back Window Reveal Molding:

8. Remove 13 nuts securing back window reveal molding to retainer assemblies and remove back window reveal molding (Figure 1).
Installation: Install components as listed in the 1986 Body Service Manual.

1. Position back window reveal molding and install retaining nuts (Figure 1).

2. Install rear compartment front panel.

3. Install rear seat to back window trim.
4. Replace center high level stop lamp and bracket.

5. Install back window garnish molding.

6. Install quarter upper trim panels.

7. Install rear seat back cushion.

8. Install rear seat cushion.

For warranty purposes, use the following Labor Operation: B8520 at 1.1 hours.