Popping When Releasing Lumbar Seat Switch

Figure 2 - Lumbar Seat Switch Pop Suppression:

Parts Required Quantity

P/N 20703379 - Suppression Jumper 1 per power seat
P/N 3816659 - Strap 1 per power seat

Procedure - Refer to Figure 2

1. Position both driver and passenger seats to their full forward positions.

2. With the ignition "off", disconnect the negative battery cable.

3. Working from the behind the driver's seat, disconnect the power feed (see Figure 2, twoway connector with black and orange/black wires) for the seat motor.

4. Install the suppression jumper to the two-way connectors and strap the harness to the adjuster cable as shown in Figure 2, View A.

5. Repeat the procedure for the passenger seat.

6. Reconnect the battery.

7. Return the seats to their normal positions.
For warranty purposes, use Labor Operation T6195 at .5 hours.