Spot/Partial Repair Method

Use standard repair procedures for any metal damage. Sand, prime, and compound the same as for any paint operation.
1. Apply primer-surfacer as required. Follow labeled directions.

NOTE: For best results, a light color primer or sealer should be used under the base coat.

2. Wet sand the primed areas and areas where the base color will be applied with #400 grit sandpaper.

3. Compound or wet sand the areas to be painted with the pearl luster coat and clear coat with ultra-fine or finer sandpaper and wash entire area with a cleaning solvent.

4. Apply adhesion promoter over the entire area to be painted.

5. Apply base color to hide. Feather out the base white in the blend areas.

6. Use the let-down panel to determine the number of pearl luster coats required to match the adjacent panels.

7. Apply the pearl luster coat over the white base area then blend beyond as required.

8. Apply clearcoat over the complete panel.