Convertible Top - Pull Down Motor Replacement
87cad10Bulletin No. T-88-64
File in Group 10
Number 115
Corp. Ref. No. 718207
Date Dec. '87
SUBJECT: SOFT/HARD TOP PULL DOWN MOTOR REPLACEMENT
MODELS AFFECTED: 1987 ALLANTE
Some 1987 Allantes may experience a condition where the jaws of the pull down motor bend or break off of its mounting bracket, or the soft top or hard top will not pull down. This condition may be caused by improper alignment of the soft/hard top hook to the jaws of the pull down motor or the incorrect soft top operation. To repair this condition use the following procedure:
Parts required for this procedure are:
Part Name P/N
Bezel - Cover 1646175
Motor - Soft/Hard Top Pull Down 1644990
Cover - Top Pull Down 1646537
Clip - Electrical Connector 1839906
1. Remove the hard top and place it on a protected surface.
2. Raise the soft top boot cover.
FIGURE 1 - ENLARGING HOLE:
3. Remove the soft top cover from the soft top cover hinge assembly and place it on a protected surface (refer to Figure 1).
FIGURE 2 - TEMPLATE:
4. Enlarge the hole on the soft top boot cover into the shape shown in Figure 1, View A by using template made from Figure 2.
FIGURE 3 - PULL DOWN MOTOR COVER:
5. Install Bezel, P/N 1646175, into the enlarged hole and bend tabs.
6. Reinstall the soft top boot cover to the hinge assembly.
7. Raise the soft top and latch it to the windshield header, but leave the back glass up and locked to the soft top frame.
8. Remove four screws retaining the pull down motor cover and remove cover (refer to Fig. 3).
FIGURE 4 - SOFT/HARD TOP RELEASE CABLE:
9. Remove the pull down motor assembly (refer to Figure 4).
10. Cut the manual release cable just above the crimp (refer to Figure 4).
11. Mark location of soft/hard top release cable at the set screw and remove the soft/hard top release cable (refer to Figure 4).
12. Reinstall the manual release cable to new soft/hard top pull down motor assembly, P/N 1644990, using electrical connector clip, PN 1839906.
NOTE: Use standard tool J-35603 terminal crimping tool to crimp electrical connector clip.
13. Reinstall soft/hard top release cable to the new soft/hard top pull down motor assembly with cable in original position as marked in step 11.
14. Reinstall new soft/hard top pull down motor (refer to Figure 4).
FIGURE 5 - PULL DOWN HOOK:
15. Unlatch and lower the soft top back glass assembly until the hook on the, soft top frame is just touching the pull down motor jaws. The pull down motor assembly should be adjusted to the point where the jaws touch the middle of the vertical forward section of the hook (refer to Figure 5).
FIGURE 6 - PULL DOWN MOTOR PIVOT:
16. Loosen the 10 mm bolts that secure the mounting bracket to the pull down motor assembly and pivot the pull down motor assembly forward or rearward (refer to Figure 6).
FIGURE 4 - SOFT/HARD TOP RELEASE CABLE:
17. Recheck alignment.
18. If further adjustment is required, remove the pull down motor assembly and install or remove flat washers on the mounting studs as necessary (refer to Figure 4).
FIGURE 3 - PULL DOWN MOTOR COVER:
19. Install soft/hard top to pull down motor cover, P/N 1646537, (refer to Figure 3).
20. Lower the soft top to its stowed position.
21. Lower the soft top boot cover.
22. Install the hard top and verify the adjustment of die hard top hook.
For warranty purposes, use Labor Operation T6268 at .7 hour.