1987-1988 Allantes Procedures

1987-1988 Allantes (Refer to Figures 1-3):

1. Remove canister from vehicle following the procedure outlined in Section 6E-C3 of the appropriate Service Information Manual.





For steps 2-7 refer to Figure 1.


2. Remove the bucket.

3. Snap out the inner support and discard.

4. Insert vent cap, P/N 8640496, into one end of hose using hose material, GM 6165-M, 20.5" long, 5/16" I.D.

5. Install open end of hose onto funnel and clamp to base with a hose clamp.

6. Snap funnel, P/N 7021697, onto the bottom of the canister.

7. Route hose through the opening in bucket created in step 3 and reinstall canister and bucket per Section 6E-C3 of the appropriate Service Information Manual.





8. Route the hose through the LH wheelhouse panel. Refer to Figure 2.


IMPORTANT: Use the LH wheelhouse panel to avoid kinking the vent hose.





9. Attach free end of hose to hole in lower fan support using clip, P/N 3866187, and screw, P/N 11514845. Refer to Figure 3.

IMPORTANT: Make sure the hose is not routed close to the fan blades, as damage to the hose could result.

For warranty purposes use Labor Operation T6586 at .4 hour.