Operation CHARM: Car repair manuals for everyone.

Without Speed Density Update

Chart - Code 43 Electronic Spark Control:




Wiring Diagram for Electronic Spark Control Circuit:






CIRCUIT DESCRIPTION:
The knock sensor is used to detect engine detonation and the Electronic Control Module (ECM) will retard the electronic spark timing based on the signal being received. The circuitry within the knock sensor causes the ECM 5 volts to be pulled down so that under a no knock condition, CKT 496 would measure about 2.5 volts. The knock sensor produces an AC signal which rides on the 2.5 volts DC voltage. The amplitude and signal frequency is dependent upon the knock level. If CKT 496 becomes open or shorted to ground, the voltage will either go above 3.5 volts or below 1.5 volts. If either of these conditions are met for about 1/2 second, a Code 43 will be stored.

TEST DESCRIPTION:
Numbers below refer to circled numbers on the diagnostic chart.
1. This step determines if conditions for Code 43 still exist (voltage on CKT 496 above 3.5 volts or below 1.5 volts). The system is designed to retard the spark 6 degrees, if either condition exists.
2. The ECM has a 5 volts pull-up resistor, which applies 5 volts to CKT 496. The 5 volts signal should be present at the Knock sensor terminal during these test conditions.
3. This step determines if the Knock sensor resistance is 3300 to 4500 ohms, the sensor is OK.
4. If CKT 496 is not open or shorted to ground and the voltage reading is below 4 volts, the most likely cause is an open circuit in the ECM. It is possible that a faulty Mem-Cal could be drawing the 5 volts signal down and it should be replaced, if a replacement ECM did not correct the problem.

DIAGNOSTIC AIDS:
Check CKT 496 for a potential open or short to ground. Also, check for proper installation of MEMCAL. See "DIAGNOSIS BY SYMPTOMS." Testing and Inspection