Rear Door - Window Regulator Tape

Rear Door Regulator Service Parts:

REMOVE OR DISCONNECT
1. Regulator from door important to reconnect wire harness to motor. Reconnect window switch to wire harness.
2. Tape from regulator by using a thin-bladed screwdriver and separating tape from tabs on housing and running tape out of regulator. On 6CH23-33 styles, remove rivet located through tape and regulator using a 4.8 mm (3/16") drill bit.
3. Guide from tape. Important to cut service tape to length specified.

INSTALL OR CONNECT
1. Guide to tape, making sure tabs on guide are into last four holes of tape.
2. Tape to regulator by feeding tape until contact is made with drive gear; then running regulator to complete feeding of tape. Position last hole in tape over the last tab on regulator housing. This is required for proper glass travel.
3. Drill 3/16" hole through service tape in line with hole in regulator on 6CH23-33 styles and install a 3/16" x 3/8" rivet through tape and regulator.