Rocker Arm Cover - Left

REMOVE OR DISCONNECT






1. Negative battery cable.
2. Air cleaner.
3. PCV valve.
4. Throttle return spring.
5. Accessory drive belt.
6. Loosen two lower power steering pump bracket nuts.
7. Power steering pump, belt tensioner and bracket assembly and position out of way toward front of engine.
8. LH spark plug wires and conduit.
9. Seven rocker arm cover attaching screws.
10. Rocker arm cover.
11. Rocker arm cover seal.
12. Triangular seals and discard.

CLEAN
1. Sealing surfaces of:
^ Intake manifold.
^ Cylinder head.
^ Rocker arm cover.

INSPECT
1. Sealing surfaces of intake manifold and cylinder head for damage. Nicks and deep scratches should be filled with RTV just before rocker arm cover installation.

INSTALL OR CONNECT

Rocker Arm Cover Sealing:

1. New triangular seals.
2. Molded seal into groove in rocker arm cover.
3. Rocker arm cover.
4. Seven rocker arm cover attaching screws.

TIGHTEN
^ Attaching screws to 10 Nm (8 ft. lbs.).

5. LH spark plug wires and conduit.
6. Power steering pump and belt tensioner bracket assembly and belt.
7. Throttle return spring.
8. PCV valve.
9. L/H spark plug wires and conduit.
10. Air cleaner.
11. Negative battery cable.