A/C - Revised Compressor Replacement Procedure
88cadillac13Bulletin No. T-89-33
File in Group 1
Number 56
Corp. Ref. No. 801201R
Date Nov. 1988
SUBJECT: AIR CONDITIONING COMPRESSOR REPLACEMENT PROCEDURE
MODELS AFFECTED: 1985-1988 DE VILLES AND FLEETWOODS
This bulletin supersedes Serviceman Bulletin T-86-53 which should be discarded.
FIGURE 1 - 1985-1987 LIQUID LINE FILTER (P/N 25535702):
FIGURE 2 - 1988 LIQUID LINE FILTER (P/N 25535703):
The new service liquid filter assemblies are currently available from GMSPO for 1985-1988 DeVilles and Fleetwoods. The service liquid line filter assemblies contain an integral refrigerant system filter which eliminates the need to flush the refrigerant system after a compressor failure. The 1985-1987, refer to Figure 1, and 1988, refer to Figure 2, model liquid filter assemblies are pictured below.
When servicing the compressor in a 1985-1988 DeVille or Fleetwood, use the procedure outlined below. This procedure replaces the A/C system flushing procedure outlined in the Service Information Manual.
CAUTION: Before any service is attempted which requires opening of the refrigerant system, the technician should be thoroughly familiar with the information contained under the heading ON-CAR SERVICE in Section 1C of the Service Information Manual.
1. Replace the compressor assembly as described in Section 1C of the appropriate Service Information Manual.
2. Remove the production liquid line assembly and install the appropriate service liquid line filter assembly as described below:
A. On 1985-1987 vehicles disconnect the liquid line connection at the orifice tube. On 1988 vehicles disconnect liquid line from evaporator fitting. Remove orifice tube and inspect for debris; and if necessary, clean or replace it. If in the unlikely event a screen on the orifice tube is ripped, the evaporator core, and orifice tube must be replaced. Discard old O-ring and install new GM replacement neoprene O-ring, P/N 3094217.
B. Disconnect liquid line connection at the condenser.
C. Remove liquid line from vehicle, D. Remove high side temperature sensor from production liquid line, discard old O-ring, and install new GM replacement neoprene O-ring, PN 3093509.
E. Lubricate all O-rings with refrigerant oil.
F. Install high side temperature sensor in service liquid line filter assembly.
G. On 1985-1987 vehicles install orifice tube in service liquid line filter assembly.
H. Install liquid line filter assembly in vehicle.
I. Connect liquid line connection at the condenser.
J. On 1985-1987 vehicles connect the liquid line connection at the orifice tube. On 1988 vehicles connect the liquid line connection at the evaporator.
For warranty purposes use Labor Operation D4440 at .7 hour for compressor replacement with an add time of .4 hour for liquid line assembly replacement and an add time of .5 hour for discharge/charge A/C system. The add hours for component flushing will no longer be paid on 1985-1988 DeVilles and Fleetwoods, flushing is not necessary when the liquid line filter assembly is used.