Popping When Releasing Window Switch - Eldorado
Figure 3 - Eldorado Power Window Jumper Harness Installation:
Parts Required Ouantity
P/N 20700250 - Jumper Harness 2
P/N 3816659 - Strap 2
Procedure - Refer to Figure 3
1. With ignition off, disconnect the negative battery cable.
2. Remove left door trim as described in Section 5D of the Body Service Manual.
3. Disconnect cross car harness from window motor.
4. Reroute cross car harness window motor lead from behind sheet metal and out the wide oblong opening to the right of the window motor.
5. Connect appropriate end of jumper harness to the cross car harness window motor lead.
6. Route the free end of the jumper harness behind the cross car harness and behind the sheet metal. Connect the jumper to the window motor.
7. Secure the jumper harness by strapping the middle of the jumper to the sheet metal between the wide oblong opening and the nearest narrow oblong opening.
Note: Jumper harness should form a smooth curve as shown in Figure 3 below.
8. Reinstall left door trim.
9. Repeat steps 2-8 for the right door.
10. Reconnect the battery.
For warranty purposes, use Labor Operation T6196 at 1.0 hours.