Popping When Releasing Window Switch - Seville
Figure 4 - Seville Front Door Window Motor Jumper Harness Installation:
Parts Required Quantity
P/N 20700250 - Jumper Harness 4
P/N 11501906 - Strap 4
Front Door Procedure - Refer to Figure 4
1. With ignition "off", disconnect the negative battery cable.
2. Remove left front door trim as described in Section 5D of the Body Service Manual.
3. Disconnect cross car harness from window motor.
4. Reroute cross car harness window motor lead from behind sheet metal and out the small oblong opening as shown in Figure 4.
5. Secure window motor lead to sheet metal with tie strap.
6. Route appropriate end of jumper harness behind sheet metal to connect with power window motor.
7. Route other end of jumper harness out large trapezium shaped opening, and into first section of the conduit.
8. Position connector out of first opening of the conduit and securely connect to the cross car harness window motor lead connector.
9. Reinstall left front door trim.
10. Repeat the above steps 2-9 for the right front door.
Figure 5 - Seville Rear Door Window Motor Jumper Harness Installation:
Rear Door Procedure - Refer to Figure 5
11. Remove right rear door trim as described in Section 5D of the Body Service Manual.
12. Disconnect cross car harness from power window motor.
13. Connect appropriate end of jumper harness to the power window motor.
14. Route free end of jumper harness behind the cross car harness from behind the sheet metal and out through the oblong opening.
15. Connect cross car harness window motor lead to the end of the jumper harness which was positioned through the oblong opening.
16. Secure jumper harness and cross car harness power window motor lead by strapping them to the sheet metal between the oblong opening and the large opening which exposes the window motor.
17. Reinstall the door trim.
18. Repeat steps 11-17 for the left rear door.
19. Reconnect the battery.
For warranty purposes, use Labor Operation T6196 at 2.0 hours for Sevilles.