Popping When Applying Brake Switch
Parts Required QuantityP/N 12060761 - Suppression Jumper 1
Procedure
1. With the ignition "off", disconnect the negative battery cable.
2. Turn ignition off and remove left-hand sound insulator as described in Section 8C of the Service Manual.
3. Disconnect electrical connector from brake switch and remove two terminals from brake switch connector body. Discard connector body.
4. Remove two single cavity male connector bodies from jumper harness, P/N 12060761.
5. Install brake switch terminals (removed in step 3) into single cavity male connnector bodies.
6. Reconnect single cavity connectors to matching wire colors.
7. Connect three cavity jumper harness connector to brake switch. Reinstall left-hand sound insulator.
For warranty purposes, use Labor Operation T6158 at .3 hours.