Antenna: Service and Repair

ANTENNA ASSEMBLY-REMOVAL

Power Antenna Mounting:

NOTE: Before beginning the removal process turn front wheels all the way to right for easier access.

REMOVE OR DISCONNECT
1. Negative battery cable.
2. Antenna lead-in from radio or splitter (access gained by partially lowering right hand sound insulating panel).
3. Electrical connector for antenna motor.
4. Rear portion of wheel opening shield (5) and push aside.
5. Screws from top of antenna tube (10).
6. Screws from lower mounting bracket (6, 9).
7. Grommet (7) from body.
8. Antenna assembly with lead-in and wire harness.

INSTALL OR CONNECT
1. Screws at top of antenna tube (10).
2. Screws into lower bracket (6, 9).
3. Grommet (7) into body.
4. Wheel opening shield (5).
5. Antenna lead-in (and sound insulating panel).
6. Electrical connector.
7. Battery negative cable.

NOTE: To replace antenna assembly follow procedures with service replacement part.