Output Cycling

This mode can be initiated after E.9.5 is displayed on the "Data Center". The display of E.9.5 can be reached by depressing the "HI" button while code .7.0 is displayed. The ECM output cycling mode, code E.9.6 turns the ECM's outputs on and off.

To enter the output cycling mode, proceed as follows:

1. The engine must be running.
2. Turn the engine off and within 2 seconds, turn the ignition on but do not start the engine.
3. Enter diagnostics and display code E.9.5.
4. Depress the accelerator pedal (throttle switch open) and release it (throttle switch closed). The ECM output cycling mode begins as the display switches from code E.9.5 to code E.9.6. (if the display doesn't advance to code E.9.6, use the chart for ECM switch test E.7.2.
5. Turn the cruise instrument panel switch to the on position so that the Cruise Control outputs will cycle.
6. The output cycling mode will end automatically after 2 minutes of cycling and the display will switch from code E.9.6 to code E.9.5.

The outputs will cycle on and off every 3 seconds until the 2 minute automatic time-out occurs. If additional output cycling is desired, recycle the throttle switch.