Body - Rear Door Contacts Quarter Wheel Opening Molding
89cadillac09Bulletin No. T-89-125
File in Group 10
Number 155
Corp. Ref. No. 911507
Date July, 1989
SUBJECT: REAR DOOR CONTACTS QUARTER WHEEL OPENING MOLDING
MODELS AFFECTED: 1989 SEDAN DE VILLES
Figure 1 - Contact Point:
Some 1989 Sedan DeVilles may experience a condition of the rear door lower corner contacting the quarter wheel opening molding when opening the door. Refer to Figure 1. This condition may be caused by the expansion of the rear wheel opening molding in warm temperatures and high humidity. To repair this condition use the following procedure:
1. Make sure door edge guards are properly installed.
2. Remove rear wheel.
Figure 2 - Removing Screw:
3. Loosen the rear section of the rocker panel molding by removing the screw at the bottom of the rear wheel opening. Refer to Figure 2.
Figure 3 - Removing Rocker Molding:
4. Remove the two screws retaining the rocker molding in the door opening, and release the molding by sliding it downward off of the clip on the wheel opening molding. Refer to Figure 3.
5. Remove the screw and clip at the leading edge of the wheel opening molding.
6. Remove the front and center 11 mm wheel opening retainer nuts.
Figure 4 - Elongating Hole:
7. Hold the molding out from the quarter panel and elongate the front hole downward 1/8 inch. Refer to Figure 4.
8. Touch up bare metal with a zinc-rich primer.
9. Install the molding and finger tighten the two 11 mm nuts.
Figure 5 - Drilling New Hole:
10. Push down on the leading edge of the molding to achieve a flush fit of the molding to the dog leg, refer to Figure 5, and drill a new hole for the rocker molding clip.
11. Touch up holes with zinc-rich primer.
12. Install the rocker molding clip and tighten the two 11 mm nuts (specified torque is 6 - 9 N-m).
13. Reinstall the rocker panel molding.
14. Reinstall wheel.
For warranty purposes use Labor Operation T6386 (LH) and T6387 (RH) at .6 hour for each side.