Test C: Starter Enable Relay Test
Test C:
C2: Connect a fused jumper between terminals 4 (YEL) wire and 1 (YEL) wire of the Starter Enable Relay Connector. Turn Ignition Switch to START.
^ If engine cranks proceed to C3.
^ If engine does not crank, diagnose Starter and Charging Circuits.
C3: Reconnect the Starter Enable Relay and connect a fused jumper from terminal A3 (ELK) wire of the PASS Key Decoder Module to ground. Turn Ignition Switch to START.
^ If engine cranks, replace the PASS Key Decoder Module.
^ If engine does not crank, check the ELK (625) wire for an open. If wire is OK, replace the Starter Enable Relay.