General

^ Try the following checks before doing the System Check.

1. Check Fuse 6 and the WHT (93) wires by operating the Headlight Washer.

2. Check the Wiper/Washer Motor Module connector terminal contact.

3. If Wipers cycle in and out of park position in HI, and do not operate in LO, MIST, or PULSE, check YEL (196) wire for an open (see schematic).

4. If the Wiper Motor runs but the wiper blades do not, check the wiper linkage at the wiper crank arm.

5. If the Washer does not operate, check that:

^ Washer reservoir is filled.

^ Hoses are not pinched or kinked.

^ Hoses are correctly attached.

^ Nozzles are not clogged.

6. Check connector terminal contact at connectors C218 and C200.

7. Check connector terminal contact at the Right Switch Pod.

^ Go to System Check for a guide to normal operation.

^ Go to System Diagnosis for diagnostic tests.