Snapshot Mode

Snap Shot Mode Operation:

Selection of the "SNAPSHOT?" test type while in the BCM system level will allow the recall of up to three snapshots recorded at the time of the setting of BCM malfunction codes. Additionally, one may trigger the recording of a snapshot upon demand. Selecting snapshot (by pushing the "HI" button) while in the BCM system, will result in the display of "BXXX" where "XXX" is the 3 digit diagnostic code that recorded the snapshot.

While selecting snapshot, any of the following actions may be taken to control the display:

1. Depressing the "OFF" button on the ECC panel will stop the test type selection process and return the display to the next available system selection.

2. Depressing the "LO" button will allow scrolling through the list of BCM diagnostic codes that the BCM has stored a snapshot for. After the last BCM diagnostic code, (or the third if there are more than three codes set) pressing the "LO" button will result in the "TAKE BCM SNAPSHOT?" display. Responding "LO" will return to the first "BXXX SNAP?" display.

3. Depressing the "HI" button will "SNAP DATA?" or "SNAP INPUTS?" to be displayed and will select that test type. At this point the display is controlled as it would be for non-snapshot data and input displays. However, all values and status information represents memorized vehicle conditions.