Keyless Entry: Service and Repair

PROGRAMMING PROCEDURE
Do the following when replacing Keyless Entry Module or either transmitter.

1. Turn Ignition Switch to OFF.

2. Jumper ALDL connector terminal G (PPL/WHT) to terminal A (BLK/WHT). Door locks lock and unlock, and trunk release activates in approximately 2 seconds.

3. Press any button on one transmitter. Door locks lock and unlock, and trunk release activates in approximately 2 seconds. The first transmitter is now programmed.

4. Repeat step 3 using the other transmitter. If only one transmitter is being used, go to step 5.

5. Disconnect jumper from ALDL connector.