Snapshot

PCM/ECM CODE SNAPSHOT
The code snapshot will display the parameters of the last code stored. After .7.0 is displayed on the FDC, the code snapshot parameters can be recalled and displayed by first depressing the LO button. When E.9.0 appears on the FDC, depress the ECON and WARMER buttons at the same time. The trouble coode that the parameters are stored for will appear on the FDC. The HI and LO buttons can be used to select the desired parameter information. The parameter information will be prefixed with the letter L. Example L.0.1 would be the TPS parameter when the code was set.

PCM/ECM SNAPSHOT
This is used to diagnose intermittent conditions by capturing parameter data on demand. Enter the snap-shot mode by entering diagnostics and selecting PCM/ECM data E.9.0 on the FDC. To capture the parameter data, depress the "ECON" and "COOLER" buttons at the same time. S.9.0 will appear on the FDC when the data is captured. The HI and LO buttons can be used to select the desired parameter information. The parameter information will be prefixed with the letter S. Example: S.0.1 would be the TPS parameter when the data was captured.