Water Pump Replacement

WATER PUMP

Water Pump Assembly:

Water Pump Fasteners:

REMOVE OR DISCONNECT
^ Drain coolant.
1. Coolant recovery tank.
2. Water pump pulley (three bolts). Apply tension to drive belt to keep pulley from rotating by forcing belt tensioner into drive belt with breaker bar.
3. Accessory drive belt.
4. Water pump from vehicle.
5. Water pump gasket and discard.

CLEAN
^ Water pump and engine front cover sealing surfaces.

INSTALL OR CONNECT
1. New gasket on water pump cover studs.
2. Water pump.

TIGHTEN
^ All pump mounting bolts to the torque specifications shown.

3. Water pump pulley and install bolts finger tight.
4. Accessory drive belt.

TIGHTEN
^ Pump pulley bolts to 30 Nm (22 ft lbs) using drag of drive belt to hold pulley. If additional drag is needed, attach breaker bar to belt tensioner and apply load to belt while tightening pulley bolts.

5. Coolant recovery tank.
6. Refill coolant.