Without Electrochromic Mirrors

The Power Remote Mirrors are adjusted from inside the vehicle by moving the Outside Mirror Control Switch in the desired direction.

Each outside mirror has two reversible motors: one to adjust the mirror view up and down, the other to adjust the mirror view right and left. The driver operates either an UP-DOWN Switch or LEFT-RIGHT Switch to control the motor voltage polarity. The mirror select switch directs these controls to either the RH or LH Outside Mirror.

With the mirror select switch in the LH position and the mirror position switch held in the UP position, battery voltage from the ORN (1540) wire is applied through the mirror position switch UP contacts to the UP-DOWN motor in the LH Outside Mirror. The LH Outside Mirror UP-DOWN motor is ground through the mirror select switch LH contacts, the mirror position switch UP contacts and the BLK (152) ground wire. The LH UP-DOWN motor runs and turns the mirror up.

When the mirror position switch is pushed to the DOWN position, the LH UP-DOWN motor receives voltage. However, the polarity is reversed causing the motor to run in the opposite direction.

The LH LEFT-RIGHT motor operates similarly. When the mirror position switch is moved to the LEFT position, battery voltage from the ORN (1540) wire is applied through the mirror position switch LEFT contacts and the mirror select switch LH contacts to the LEFT-RIGHT motor in the LH Outside Mirror. The LH LEFT-RIGHT motor is grounded through the mirror position switch LEFT contacts and BLK (152) ground wire. The LH LEFT-RIGHT motor runs and turns the mirror to the left.

If the mirror position switch is pushed to the RIGHT position, the same motor receives voltage. However, the voltage polarity is reversed and the motor runs in the opposite direction.

The RH Outside Mirror works the same way as the LH Outside Mirror when the Mirror Select Switch is moved to the RH position and the UP-DOWN and LEFT-RIGHT Switches are operated.