Installation

Blower Motor And Power Module:

INSTALL OR CONNECT
1. Screws attaching power module assembly after positioning in vehicle.
- Tighten nuts to 1.4 Nm (12 lbs. in.).
2. Electrical connector to power module.
3. Nuts attaching multi-use relay and fuse bracket to front of dash after positioning in vehicle.
- Tighten nuts to 3.8 Nm (34 lbs. in.).
4. Position fuse blocks and relays to bracket and snap in.
5. Center bolt attaching positive battery cable to multi-use relay and fuse bracket after positioning cable.
- Tighten bolt to 10 Nm (89 lbs. in.).
6. Rear engine sight shield. Refer to Engine Cover Replacement Service and Repair.