Rear Wheel Speed Sensors

Rear Wheel Speed Sensor:

Rear Wheel Speed Sensor Wiring:

REMOVE OR DISCONNECT
1. Wheel speed sensor connector.
2. Hub and bearing assembly.
3. Clean all dirt and debris from sensor housing/sensor interface area.
4. Torx screws.
5. Sensor.

NOTES:
^ Do not allow debris to enter sensor housing.
^ Do not add lubricant to bearing through sensor housing opening. The bearing is lubricated for the life of the vehicle.
^ Do not clean grease from toothed sensor ring. Grease does not affect sensor operation.

6. Inspect sensor ring and sensor plate for contact. When contact is found, replace complete bearing assembly.

INSTALL OR CONNECT
1. Sensor, be sure O-ring is not torn or missing.
2. Torx screws and tighten to 3.7 Nm (33 lb in).
3. Hub and bearing assembly.
4. Wheel speed sensor connector.