Engine - Crankshaft Balancer Updated
FILE IN SECTION: 6 - EngineBULLETIN NO.: 47-61-43A
DATE: May, 1995
SUBJECT:
Updated Crankshaft Balancer
MODELS:
1993 Cadillac Allante
1993-94 Cadillac Eldorado, Seville
with 4.6L Engine (VINs V, 9 - RPOs LD8, L37)
1993 Cadillac Eldorado, Fleetwood, Seville
1993-94 Cadillac DeVille
with 4.9L Engine (VIN B - RPO L26)
This bulletin is being revised to correct proper engine to match proper part numbers. Please discard Corporate Bulletin Number 47-61-43 (Section 6 - Engine)
The crankshaft balancer for the engines identified above has been updated. The new balancer is now composed of Nodular Iron versus the previous design's Grey Iron.
Whenever servicing these engines and crankshaft balancer removal is required, refer to the proper service procedures outlined in Service Manual Section 6A2, to ensure part integrity and proper installation. Use special tool J 38416-B to remove the balancer from the crankshaft and install it using the crankshaft balancer mounting bolt. DO NOT PRY THE CRANKSHAFT BALANCER OFF THE CRANKSHAFT
If servicing a crankshaft balancer stamped with the part number 3542045. replace the balancer with the part number listed below:
Engine Grey Iron P/N Nodular Iron P/N
(Previous) (New)
4.9L 3542045 12552436
4.6L 3542045 12552437
Parts are expected to be available on June 5,1995.
The part number is located on one of the three legs extending to the outer ring of the balancer. If the balancer being serviced is stamped with the part number 3542045, always replace the balancer with the specified new part number.
The part number for the updated balancer is cast as 1255243- on the leg with the remainder of the number located on the outer ring (see Figure 1). The outer ring number will begin with a "6" indicating the balancer is for a 4.9L engine and a "7" for 4.6L engines. The next digit indicates model year and the remainder identify the Julian Date, the day of the year the balancer was produced. Aside from the "6" cast into the outer ring, the 4.9L crankshaft balancer is also identified by the key way slot cast into the balancer.
When installing a new crankshaft balancer on 4.6L or 4.9L engines, use the torque specification listed below:
Description 4.6L Engine 4.9L Engine
Crankshaft 60 Nm + 120° 160 Nm
Balancer Bolt (44 lb.ft. + 120°) (118 lb.ft.)