Rear Door - Window Regulator

Power Window Regulator - Rear Door:

REMOVE OR DISCONNECT
1. Trim panel and water deflector.
2. Tape window in full up position.
3. Three rivets to the trim panel armrest retainer bracket.
4. Rivets retaining regulator with a 6.3 mm (1/4") drill bit.
5. Sash bolts.
6. Wire connector.
7. Regulator through access hole.

INSTALL OR CONNECT
1. Regulator into door through access hole.
2. Wire connector.
3. Sash bolts 9 N.m (79 lb in).
4. Three rivets to the trim panel armrest retainer bracket.
5. Regulator to door using 6.3 mm (1/4") peel-type rivets.
6. Remove tape from window and check for proper window operation.
7. Water deflector and trim panel.