Service Procedure

SERVICE PROCEDURE

1. Raise vehicle and suitably support. Refer to Section OA of the appropriate Service Information Manual for hoist recommendations.

2. Remove splash shield. Refer to Figure 24, Callout # 2, Page IB-27 of the 1994 Eldorado/Seville Service Information Manual. Note that illustration is appropriate for all affected models and model years.





3. Locate the auxiliary engine oil cooler inlet hose and assure that the protective plastic cover is positioned against the ferrule at the radiator connector end. See Figure 1.





4. Locate the auxiliary engine oil cooler outlet hose. See Figure 1. Add plastic tie strap (Part Number 12337820) as shown in Figures 1 and 2. Assure that tie strap is around the plastic covering on both lines so that the strap does not contact bare hose.

5. Clearance of the auxiliary engine oil cooler outlet hose to the compressor clutch should be 45 mm (1.75 in.) minimum. See Figure 1.

6. Install splash shield.

7. Lower vehicle and install Campaign Completion Label.