Oil Level Sensor - New Component Service Procedure

NO.:
93-I-10

DATE:
Nov. 1992

GROUP:
8

CORP. NO.:
210106



SUBJECT:
SERVICE, PROCEDURE FOR NEW OIL LEVEL SENSOR FOR 1993 ALLANTES AND NORTHSTAR (4.6L) EQUIPPED ELDORADOS AND SEVILLES





Some 1993 Allantes are equipped with a new oil level sensor. The new sensor is identical to the earlier Northstar engine production oil level sensor with the exception of connector head configuration. Refer to Figure 1. Both parts are interchangeable for service purposes.

To properly service the new sensor the following procedure should be followed:

1. Hoist vehicle.

2. Drain engine oil.





3. Loosen oil level sensor until connector terminals are oriented 90~ with respect to the floor. Refer to Figure 2.

4. Disconnect electrical connector with a flat terminal pick or a small flat-end screw driver as indicated in Figure 2.

5. Remove and replace oil level sensor.

6. Lower vehicle and refill engine oil to proper level.

For warranty purposes use Labor Operation N4580 at .3 hour.