Initial Inspection and Diagnostic Overview

PROCEDURE
1. Check I/P Fuse #41. If it is open, check CKT 308 for a short to ground.
2. Make sure that G102, G106 and G107 are clean and tight.
3. Check bulbs and sockets for damage or corrosion.
^ Check for a broken (or partially broken) wire inside of the insulation which could cause system failure but prove "GOOD" in a continuity/voltage check. These circuits maybe intermittent or resistive when loaded, and if possible, should be checked by monitoring for a voltage drop with the system operational (under load).
^ Check for proper installation of aftermarket electronic equipment which may affect the integrity of other systems.