Door Frame

IV. Wind noise due to air leak at primary weatherstrip to door frame.

1. Adjust the door inboard to obtain necessary contact to the door frame.

V. Windshield side reveal molding gaps to door.

Adjust the door inboard so there is slight contact of the door frame along the A-pillar to the windshield side reveal molding.

VI. Front edge of the front door may be outboard slightly of the front fender.





Adjust the front edge of the front door inboard of the front fender. Flush to 1.5 mm inboard. Refer to Figure 4.

NOTE:
In rare instances it may be necessary to adjust the front fender outboard to obtain a proper fit.

VII. Front edge of the rear door may be outboard slightly of the front door.

Adjust the front edge of the rear door inboard of the front door. Flush to 1.5 mm inboard. Refer to Figure 4.

Door Assembly Align:

Labor Operation Labor Time

B4000 (Right Front) .6 hour
B4001 (Left Front) .6 hour
B4400 (Right Rear) .3 hour
B4401 (Left Rear) .3 hour