R082

Diagnostic Chart:

Wiring Diagram:

CIRCUIT DESCRIPTION

During the 'Turn-ON' tests, performed at the beginning of each ignition cycle, the DERM delays the charging of the 'DRIVER'S 36VLR' and 'PASSENGER'S 36 VLR' power supplies. While the delay is active the DERM measures the voltage at the 'DRIVER'S 36VLR' terminal 'A4', 'PASSENGER'S 36VLR' terminal 'A3', 'DRIVER'S SOURCE SENSE' terminal 'A5', and 'PASSENGER'S SOURCE SENSE' terminal 'A6'. When the voltage measured at the two '36VLR' power sup lies indicates they are in a discharged state, and the voltage measured at 'DRIVER'S SOURCE SENSE' is within a specified range of Ignition 1 voltage and the voltage measured at 'PASSENGER'S SOURCE SENSE' is a specified amount below Ignition 1 voltage Code R082 is set. If neither the failure nor clear conditions are met, the state of the fault during the previous ignition cycle is used. Code R082 indicates an open passenger ignition diode or a short between the 'PASSENGER'S SOURCE SENSE' circuit and either the 'DRIVER'S 36VLR' or 'PASSENGER'S 36VLR' circuit. Code R082 is set for the entire ignition cycle.

TEST CONDITION(S)

1. 'Turn-ON' tests active.

2. The 'DRIVER'S SOURCE SENSE' terminal 'A5' is greater than (Ignition 1-3.34 volts) and less than Ignition 1+ 2 volts).

3. Neither 'DRIVER'S 36VLR' nor 'PASSENGER'S 36VLR' terminal 'A4' or 'A3' is yet active.

4. The 'DRIVER'S and PASSENGER'S 36VLR' terminals 'A4' and 'A3' are less than (Ignition 1-4.5 volts).

FAILURE CONDITION(S)

1. The 'PASSENGER'S SOURCE SENSE' terminal A6' is less than (Ignition 1-3.34 volts).

CONDITIONS TO CLEAR

5. The 'PASSENGER'S SOURCE SENSE' input (A6) is greater than (Ignition 1-3.34 volts) and less than (Ignition 1 + 2 volts).

ACTION TAKEN

1. DERM turns on the 'INFLATABLE RESTRAINT' indicator.

2. 'SERVICE SUPPLEMENTAL INFLATABLE RESTRAINT' message is displayed on DIC.

3. Code R082 remains set for the entire ignition cycle.

4. Current Code R082 clears each time the ignition switch is cycled from 'OFF' to 'ON' if the Test Conditions are true and voltage at 'PASSENGER'S SOURCE SENSE' terminal 'A6' is greater than (Ignition 1-3.34 volts) and less than (Ignition 1 + 2 volts). If these conditions are not met the state of the fault in the previous ignition cycle will be used.

NOTES ON FAULT TREE

1. Checks for a short between the 'PASSENGER'S SOURCE SENSE' and 'PASSENGER'S 36VLR' circuits.

2. Checks for a short between the 'PASSENGER'S SOURCE SENSE' and 'DRIVER'S 36VLR' circuits.

3. Checks the Dual Pole Arming Sensor for an open ignition diode by measuring for proper voltage.