Console: Service and Repair

CONSOLE ASSEMBLY

FULL CONSOLE

Console Trim Plate:

Gear Selector Assembly:

Console Electrical Connectors:

Full Console:

REMOVE OR DISCONNECT
1. Storage compartment by pulling up and out.
2. Shift handle retaining clip and shift handle.
3. Console upper trim plate (gently pull up and out).
4. Electrical connector for cigar lighter.
5. Radio.
6. Four screws retaining console to instrument panel.
7. Gear selector trim plate (retained by clips) and PRNDL illumination lamp socket.
8. Two shifter plate upper mounting bolts.
9. Two nuts retaining shifter assembly to floor.
10. Two nuts through storage compartment opening retaining console to floor.
11. Console blower air supply duct. Turn to release.
12. Slide console up and disconnect electrical connectors.
13. Slide console back to clear shifter assembly.
14. Console from vehicle.

INSTALL OR CONNECT
1. Position console into vehicle over shifter assembly.
2. Electrical connectors.
3. Console blower air supply duct. Turn to push on.
4. Through storage compartment opening, two nuts retaining console to floor.
5. Two nuts retaining shifter assembly to floor.
6. Two shifter plate upper mounting bolts.
7. PRNDL illumination lamp socket and gear selector trim plate.
8. Four screws securing console to instrument panel.
9. Radio.
10. Electrical connector for cigar lighter and console upper trim plate.
11. Shift handle and retaining clip.
12. Storage compartment.