Output

Description:
The PCM OUTPUTS option provides the ability to cycle PCM controlled Outputs. The DIC display identifies the solenoid or relay, and what state the PCM is commanding of that device. HI indicates that the solenoid or relay is energized, and LO indicates that the solenoid or relay is de-energized. The PCM outputs tests can only by done with the engine not running. The PCM outputs available are as follows:

PO00 NONE
No Outputs. No PCM outputs are cycled while PO00 is displayed.

PO01 CAN PURGE
Evaporative Emissions Control Solenoid. The EVAP Solenoid will cycle "ON" and "OFF" approximately every 4 seconds.

PO02 TCC SOL
Torque Converter Clutch Solenoid. The TCC Solenoid will cycle "ON" and "OFF" approximately every 4 seconds.

PO03 EGR SOL
Exhaust Gas Recirculation Solenoid. The EGR Solenoid will cycle "ON" and "OFF" approximately every 4 seconds.

PO06 AIR PUMP
Not used. No PCM outputs are cycled while PO06 is displayed.

PO07 ISC MOTOR
Idle Speed Control Motor. The ISC motor will alternately extend for 2 seconds and then retract for 2 seconds.

PO08 C/C VENT
Cruise Control Vent Solenoid. The Cruise Control Vent Solenoid will cycle "ON" and "OFF" approximately every 4 seconds.

PO09 C/C VAC
Cruise Control Vacuum Solenoid. The Cruise Control Vacuum Solenoid will cycle "ON" and "OFF" approximately every 4 seconds.

PO10 SHIFT A
Transaxle Shift A Solenoid. The Transaxle Shift A Solenoid will cycle "ON" and "OFF" approximately every 4 seconds.

PO11 SHIFT B
Transaxle Shift "B" Solenoid. The Transaxle Shift "B" Solenoid will cycle "ON" and "OFF" approximately every 4 seconds.

PO20 A/C RELAY
Air Conditioning Compressor Clutch Relay. The A/C Compressor Clutch Relay will cycle "ON" and "OFF" approximately every 4 seconds.

PO21 FORCE MTR
Transaxle Pressure Control Solenoid. The TPC Solenoid will cycle "ON" and "OFF" approximately every 4 seconds.