Catalytic Converter: Service and Repair

Converter View:

Exhaust Component Installation:

REMOVE OR DISCONNECT
- Raise vehicle and support three way + oxidation catalytic converter.
- Cut intermediate pipe as shown in figure. Cut as close to weld as tool will permit.
- Exhaust manifold rear pipe flange bolts/springs.
- Converter.
- Portions of the converter outlet remaining in the intermediate pipe.


INSTALL OR CONNECT
- Converter. Position intermediate pipe for needed clearance during converter installation.
- Exhaust manifold rear pipe to converter seal.
- Exhaust manifold rear pipe flange bolts/springs.
- Guillotine type clamp.

INSPECT
- Rear pipe flange bolts to 25 N-m (18.5 lbs. ft.).
- Clamp nuts to 50 N-m (37 lbs. ft.).