- Disabling the SIR System

DISABLING THE SIR SYSTEM

CAUTION: When performing service on or around SIR components or wiring, follow the procedures listed below to temporarily disable the SIR system. Failure to follow procedures could result in possible air bag deployment, personal Injury or otherwise unneeded SIR repairs.

The DERM can maintain sufficient voltage to cause a deployment for up to 10 minutes after the Ignition Switch is turned off and the battery is disconnected. Many of the service procedures require disconnection of the "SIR" fuse and Inflator Module from the deployment loop to avoid an accidental deployment.

REMOVE OR DISCONNECT

* Turn ignition switch "OFF".

1. "SIR" Fuse.
2. Lower trim panel - LH.
3. Connector Position Assurance (CPA) and yellow two-way SIR connector at the base of the steering column.