Parts and Service Procedure

PARTS INFORMATION





The parts required to complete this campaign should be obtained from the Parts Distribution Centers of General Motors Service Parts Operations (GMSPO). A description is provided (see illustration).

If there is difficulty obtaining these parts using normal ordering procedures, dealers may place a "CIO" order using advise code "2" with no special instruction code. If necessary, these parts may also be ordered on a "VIP" order and Cadillac will reimburse dealer for any surcharge involved.


SERVICE PROCEDURE

1. Remove cruise control servo. This must be done to allow proper visual access and working space. Refer to Section 9B, page 9, of the 1993 Eldorado/Seville Service Information Manual.

2. Place the flat side of a 10 mm open-end wrench against the face of the fuel pipe connector.

3. Push down on the face of each connector away from the fuel pipe. Observe to see if the intake manifold fuel pipe flange is visible. If the flange is fully visible, the connection is not complete. Proceed to Step 4.

If four (4) metal tangs can be observed in front of the flange, the connection is complete. Proceed to Step 6.

4. Pull the fuel pipe connector toward the intake manifold fuel pipe and snap into lace. An audible click noise should be apparent as the four (4) tangs lock over the Range.

5. If the connection can not be completed, pull the connector completely off and inspect the two (2) O-rings for a cocked or dislodged position. If an O-ring is cocked or dislodged, it may be damaged. Replace the fuel pipe bundle. Refer to Section 6C, page 49, of the 1993 Eldorado/Seville Service Information Manual.

6. Fill fuel tank to full capacity (20 gallons).

7. Install Campaign Completion Label.