Display Codes

Harness Connector Faces:

Code Playout:

READING CODES

The diagnostic system may be actuated by grounding the Diagnostic Enable circuit at pin "C" of the DLC or by grounding pin "D2" to "D16" of the control module connector. After pin "C" is grounded, the lamp will be "ON" for 7.5 seconds before beginning the blink code diagnostic sequence. This is followed by displaying Code 12, three times to mark the beginning of the sequence. Then each stored error code is blinked out, in ascending order. Each code is displayed three times before proceeding to the next code. When all codes have been read, the entire code sequence will repeat, starting by blinking Code 12, three times. The sequence will repeat until the Diagnostic Enable circuit is disconnected.

Codes are read by counting the number of flashes of the L.E.D. on the control module. A Code 12 would be indicated by the lamp flashing once, followed by a one second pause, followed by two flashes with a half second pause between flashes. There is a three second pause between codes.

If the diagnostic mode is entered, and no codes are stored in memory, the control module will continually display Code 12.

ERROR CODES

The Speed-Sensitive Suspension system has the ability to display the following diagnostic codes:

Code 12 Initiation Code

Code 23 Left Front Actuator Error

Code 24 Right Front Actuator Error

Code 25 Left Rear Actuator Error

Code 26 Right Rear Actuator Error

Code 31 Lift / Dive Input Error

Code 32 Lateral Acceleration Switch Error

Code 35 Speed-Sensitive Steering Error