Fuel Tank: Description and Operation
Fuel Tank And Hoses:
Fuel Tank Installation:
FUEL TANK
The fuel storage tank is made of high density polyethylene and is located in front of the rear wheels. It is held in place by two metal straps attached to the underbody of the vehicle. The tank shape includes a sump to maintain a constant supply of fuel around the fuel pump strainer during low fuel conditions or aggressive maneuvers. The tank also contains a remote fuel vapor vent valve with roll-over protection. The vent valve also features a two phase vent calibration which increases fuel vapor flow to the canister when operating temperatures increase the tank pressure beyond an established threshold.
FUEL TANK FILLER CAP
The fuel tank filler neck is equipped with a screw type cap. The threaded part of the cap requires several turns counterclockwise to remove. The long threaded area was designed to allow any remaining fuel tank pressure to escape during the cap removal operation. A ratchet type torque limiting device prevents over-tightening. To install, turn the cap clockwise until a clicking noise is heard. This signals that the correct torque has been reached and the cap is fully seated.
NOTE: If a fuel filler cap requires replacement, only a cap with the same features should be used. Failure to use the correct cap can result in a serious malfunction of the system.
FUEL AND VAPOR PIPES
The fuel feed and return pipes extend from the fuel pump/gauge sending unit to the engine compartment. The pipes are secured to the underbody with clip and screw assemblies. Both fuel feed pipes and return pipe must be properly routed and retained, and should be inspected occasionally for leaks, kinks, or dents. If evidence of dirt is found in the fuel injector assembly or fuel filter during disassembly, the pipes should be disconnected and blown out. Check the fuel strainer on the fuel pump/fuel gauge assembly for damage or omission.
The vapor pipe extends from the fuel pump/gauge assembly to the canister. However, it may not follow the same route as the fuel feed pipe.
Due to the fact that the fuel pipes/hoses are under high pressure on fuel injected systems these systems require special consideration for service.
NYLON FUEL LINES
Nylon fuel lines are designed to perform the same function as the steel or rubber fuel lines they are replacing. Nylon lines are made to withstand maximum fuel line pressure, exposure to fuel additives, and changes in weather. There are two sizes used: 3/8" ID for the fuel feed and 5/16" ID for the fuel return. The fuel feed and return lines are assembled and serviced as an assembly. Quick connect type fittings are used at the ends of the fuel feed/return lines and at the in-line fuel filter.
Nylon fuel lines are somewhat flexible and can be formed around gradual turns under the vehicle. Nylon lines, if forced into sharp bends, will kink and restrict fuel flow. Special care should be taken when working with nylon fuel lines. Nylon fuel lines cannot be repaired and can only be replaced with the proper part number replacement.
Nylon Fuel Line Tool:
QUICK CONNECT FITTINGS
Quick connect type fittings provide a simplified means of installing and connecting fuel system components. Two types of quick disconnect fittings are used at various parts of the fuel system. O-rings, located inside the female socket provide the fuel seal. One type quick disconnect fitting uses hand releasable locking tabs. The other type of quick disconnect fitting has a locking tab that requires the use of a special tool.
FUEL LINE O-RINGS
The fuel line O-rings used are made of Viton. They are brown in color. Viton is less affected than rubber by the additives used in many fuels. Therefore, rubber should not be used.