Ignition Control Module: Service and Repair

Distributor Disassembly, Test And Reassembly - Part 3 Of 3:

REMOVE OR DISCONNECT
1. Distributor cap.
2. Distributor rotor.
3. ICM attaching screws. Lift shield and ICM up.
4. Leads from ICM.

CAUTION: Do not wipe grease from ICM or distributor base if same ICM is to be replaced. If a new ICM is to be installed, a package of silicone grease will be included with it. Spread the grease on the metal face of the ICM and on the distributor base where the ICM seats. This grease is necessary for ICM cooling.

INSTALL OR CONNECT
1. Leads to ICM.
2. ICM shield and module attaching screws.
3. Distributor rotor.
4. Distributor cap.