Radio/Stereo: Service and Repair

Fig. 10 Radio Removal:

Console Shift
1. Using a putty knife, remove radio trim plate, Fig.10 .
2. Remove console trim plate by pulling up the upper edge first.
3. Remove two nuts from bottom of control head.
4. Position control head so that the right side is removed first, to clear connectors on left side.
5. Disconnect electrical connectors, then remove radio.
6. Reverse procedure to install.

Fig. 11 Radio Removal:

Column Shift
1. Remove radio trim, then the four screws from side bracket, Fig.11.
2. Remove control head, then disconnect electrical connectors.
3. Reverse procedure to install.