Deck Lid/Hatch Release

TRY THE FOLLOWING CHECKS BEFORE DOING SYSTEM DIAGNOSIS
1. Check LH Maxi Fuse Block Circuit Breaker 3, if open check RED (742) for a short to ground.
3. Check for proper installation of aftermarket electronic equipment which may affect the integrity of other systems.
4. Check for a broken (or partially broken) wire inside of insulation which could cause system malfunction but prove "GOOD" in a continuity/voltage check with a system disconnected. (Refer to Diagnostic Aids for General Troubleshooting Procedures) Diagnostic Aids
5. Visually inspect Trunk Lid Release Solenoid connector and associated wiring.
^ Refer to Symptom Table for diagnostic charts.