Ignition Lock Cylinder

Fig. 1 Lock Cylinder Set Removal:

WARNING:
On models equipped with Airbags, Refer to Air Bags (Supplemental Restraint Systems) Service and Repair Disarming procedures before performing any repair. Service and Repair

1. Disconnect battery ground cable, then remove steering wheel. Refer to Steering and Suspension / Steering / Steering Wheel.
2. Remove turn signal switch. Refer to Lighting and Horns / Turn Signals / Turn Signal Switch. Service and Repair
3. Remove key from lock, then the buzzer switch assembly.
4. Place key in "Lock" position, then remove lock retaining screw, Fig.1.
5. Disconnect electrical connector, retaining clip from housing cover, then withdraw lock cylinder assembly from column.
6. Reverse procedure to install. Torque lock retaining screw to 22 lb in