Knock Sensor Module

PCM With Knock Sensor Module:

Removing Knock Sensor Module From PCM:

KNOCK SENSOR MODULE
To gain access to the Knock Sensor (KS) module, remove the access cover from the top of the Powertrain Control Module (PCM) as shown in the accompanying images.

REMOVE OR DISCONNECT
1. Negative battery cable.
2. PCM from mounting bracket. Refer to Powertrain Control Module/Service and Repair. Service and Repair
3. Knock sensor module access cover.
4. Knock sensor module.

INSTALL OR CONNECT

NOTE: To prevent possible electrostatic discharge damage to the PCM and KS module, Do Not touch the connector pins or soldered components on the circuit board.

1. Knock sensor module.
2. Access cover.
3. PCM to mounting bracket.
4. Negative battery cable.