Throttle Position Sensor (TPS) Replacement

Throttle Body Assembly:

REMOVE OR DISCONNECT
1. Electrical connector.
2. Two Throttle Position (TP) sensor attaching screws, lockwashers and retainers.
3. Throttle position sensor.

INSTALL OR CONNECT
1. With throttle valve in the normal closed idle position, install throttle position sensor on throttle body assembly, making sure TP sensor pickup lever lines up with tang on throttle actuator lever.
2. Retainers and two TP sensor screws. Tighten TP sensor attaching screws to 2.0 Nm (18 lb in).

IMPORTANT: If a new TP sensor has been installed, refer to Throttle Position Sensor Learn Procedure. Idle Learn Procedure